README for the MASSES image data for the pointing toward Per-emb-24.

For each tracer, four images are delivered. Images are made using two different Briggs robust parameters of -1 and 1 (robust-1 and robust1).
The robust-1 is higher resolution while robust1 has less noise.
For each robust weighting, one delivered image is not corrected for the primary beam, while the other is corrected for the primary beam (labeled with 'pbcor').
Images not corrected for the primary beam are typically used for mapping structure, while those corrected for primary beam are typically used for measuring accurate fluxes.
For this source, the 1.3 mm continuum robust-1 image was not as high resolution as the robust1 image, and thus the 1.3 mm continuum robust-1 maps are not delivered.

The format for each image data cube in a MASSES dataverse is:
[targetname].[linename].robust[weighting].fits
[targetname].[linename].robust[weighting].pbcor.fits

Continuum images are delivered for 1.3 mm and 850 um.
The delivered spectral lines at 1.3 mm are 12CO21, 13CO21, C18O21, and N2DP.
Only the H13COP spectral line is delivered for 850 um (the chunk for 12CO32 and HCOP was dropped due to a power supply error).
Table A3 in the full data release paper indicates which lines are detected for each pointing.

For Per-emb-24, there are two SUB tracks.
Track 151122 was taken with the ASIC correlator.
Track 151127 was taken with the ASIC correlator.
For Per-emb-24, there is a single EXT track taken with the SWARM correlator: 161024
No 850 um data was taken in the EXT configuration.
All tracks were combined when imaging.

To import a fits image into miriad, the "fits" task should be used. "op=xyin" should be specified. We show an example for CO(2-1) below:
fits in=Per24.12CO21.robust1.fits out=Per24.12CO21.robust1.cube op=xyin

While casa can directly handle fits image files, to import the file into casa format, the task importfits can be used:
importfits(fitsimage="Per24.12CO21.robust1.fits",imagename="Per24.12CO21.robust1.cube")
